R&S RTO6 - 13.10.2.2 Advanced settings; 13.10.2.3 Configuring SENT protocol

Protocol analysis
R&S
®
RTO6
642User Manual 1801.6687.02 ─ 05
Remote command:
BUS<m>:
SENT:PPFLength
on page 1902
Show thresholds
If enabled, the threshold levels are displayed in the diagram.
Remote command:
BUS<m>:THReshold on page 1671
13.10.2.2 Advanced settings
Access: [Bus] > "Advanced" tab.
Autoset
Starts software algorithms for determining the signal threshold levels and bitrate.
Remote command:
BUS<m>:FAUToset
on page 1671
13.10.2.3 Configuring SENT protocol
The configuration of the SENT is simple - assign the two lines to input channels, and
set the thresholds.
For details on configuration settings, see Chapter 13.10.2.1, "SENT configuration",
on page 639.
1. Press the [Bus] key on the front panel.
2. Select the tab of the bus you want to set up, for example "SB1".
3. Tap the "Protocol" button and select the protocol: "SPI".
4. Tap the "Data" button, and select the waveform of the data line.
5. If necessary, set the "Transmission Setup" parameters.
6. Set the logical thresholds.
7. Enable "Decode".
SENT (option R&S R
T
O6-K520)