Network operation and remote control
R&S
®
RTO6
1235User Manual 1801.6687.02 ─ 05
●
"Ping Client" provides the ping utility to verify the connection between the instru-
ment and other devices.
IP configuration
The "LAN Configuration > IP configuration"
web page displays all mandatory LAN
parameters and allows their modification.
The "TCP/IP Mode" configuration field controls how the IP address for the instrument
gets assigned (see also Chapter 22.2.2, "Assigning the IP address", on page 1229).
For the manual configuration mode, the static IP address, subnet mask, and default
gateway are used to configure the LAN. The automatic configuration mode uses DHCP
server or Dynamic Link Local Addressing (automatic IP) to obtain the instrument IP
address.
Changing the LAN configuration is password protected. The password is LxiW
ebIfc
(notice upper and lower case characters). This password cannot be changed in the
current firmware version.
Advanced config
The "LAN Configuration > Advanced Config" parameters are used as follows:
●
mDNS and DNS-SD are two additional protocols: Multicast DNS and DNS Service
Discovery. They are used for device communication in zero configuration networks
working without DNS and DHCP
●
"ICMP Ping" must be enabled to use the ping utility
.
Web interface
To Next Page
Loading...
