R&S RTO6 - 13.15.5.2 Ethernet search results

Protocol analysis
R&S
®
RTO6
740User Manual 1801.6687.02 ─ 05
Error Condition
Searches for the following error conditions:
"Preamble Error"
or "Length Error".
Preamble Error ← Error Condition
Searches for any preamble errors.
Remote command:
SEARch:TRIGger:ETHernet:
ERRor:PREamble on page 2035
Length Error ← Error Condition
Searches for any length errors.
Remote command:
SEARch:TRIGger:ETHernet:ERRor:LENGth on page 2035
13.15.5.2 Ethernet search results
To get search results, "Enable" the search. You can minimize, shift or close the search
dialog.
The search results are listed in the search result table and marked in the waveform by
blue lines.
For an introduction to search results, see:
●
Chapter 11.1.2, "Search results", on page 420
●
Chapter 11.4.2, "Display zoom settings", on page 440
Remote commands:
●
SEARch:RESult:ETHernet:WCOunt? on page 2035
●
SEARch:RESult:ETHernet:WORD<m>:TYPE? on page 2037
●
SEARch:RESult:ETHernet:WORD<m>:FTYPe? on page 2038
●
SEARch:RESult:ETHernet:WORD<m>:STATe? on page 2036
●
SEARch:RESult:ETHernet:WORD<m>:STARt? on page 2036
●
SEARch:RESult:ETHernet:WORD<m>:STOP? on page 2037
●
SEARch:RESult:ETHernet:WORD<m>:DESTaddress? on page 2037
●
SEARch:RESult:ETHernet:WORD<m>:SRCaddress? on page 2037
Ethernet 10BASE-T and 100BASE-TX (option R&S R
T
O6-K540)