R&S RTO6 - 15.1.5.3 Scope waveform

Waveform generator (Option R&S RTO6-B6)
R&S
®
RT
O6
1031User Manual 1801.6687.02 ─ 05
Select waveform
When a multichannel file is loaded into the arbitrary waveform generator
, a dialog
appears to select which waveform from the file is loaded.
Select the waveform and press
"Load" to load it into the arbitrary waveform generator.
Remote command:
WGENerator<m>:ARBGen:MULTichannel:NAME on page 2453
WGENerator<m>:ARBGen:MULTichannel:IMPort on page 2453
WGENerator<m>:ARBGen:MULTichannel:OPEN on page 2453
15.1.5.3 Scope waveform
For a scope waveform, the following settings are available:
Signal source
Selects the oscilloscope source, from which the arbitrary signal is loaded.
Remote command:
WGENerator<m>:
ARBGen:
SELect on page 2455
Load
Loads the waveform from the selected "Signal source".
Remote command:
WGENerator<m>:ARBGen:COPY on page 2453
Setup of the waveform generator