R&S RTO6 - 13.16.5.2 MDIO search results

Protocol analysis
R&S
®
RTO6
753User Manual 1801.6687.02 ─ 05
ST
Selects the start of frame code of the frame pattern; available only in search criteria
type "Data". Permissible frame patterns are: Clause 22, Clause 45, or Any
Remote command:
SEARch:
TRIGger:MDIO:
ST on page 2050
OP
Selects the Type of Frame code (or OP code, OpCode, operation code); available only
in search criteria type "Data". Available frame types are: Address, Write, Read, Post
Read, or Any
Remote command:
SEARch:TRIGger:MDIO:FRAMetype on page 2049
PHYAD/PRTAD
Sets the physical address or port address (5 bits) of the frame pattern; available only in
search criteria type "Data".
Remote command:
SEARch:TRIGger:MDIO:PHYS on page 2050
REGAD/DEVAD
Sets the register address or device address (5 bits) of the frame pattern; available only
in search criteria type "Data".
Remote command:
SEARch:TRIGger:MDIO:REGI on page 2050
DATA/ADDRESS
Defines the payload data pattern or address pattern (16 bits); available only in search
criteria type "Data".
Remote command:
SEARch:TRIGger:MDIO:DATA on page 2049
13.16.5.2 MDIO search results
To get search results, "Enable" the search. You can minimize, shift or close the search
dialog.
The search results are listed in the search result table and marked in the waveform by
blue lines.
For an introduction to search results, see:
●
Chapter 11.1.2, "Search results", on page 420
●
Chapter 11.4.2, "Display zoom settings", on page 440
Remote commands:
●
SEARch:RESult:MDIO:WCOunt? on page 2055
●
SEARch:RESult:MDIO:WORD<m>:STATe? on page 2053
●
SEARch:RESult:MDIO:WORD<m>:STARt? on page 2053
MDIO (option R&S R
T
O6-K540)