R&S RTO6 - 13.6.2 Custom: Manchester; NRZ configuration; 13.6.2.1 Custom: Manchester; NRZ configuration settings

Protocol analysis
R&S
®
RTO6
549User Manual 1801.6687.02 ─ 05
with eventual Manchester coding violations. In these situations, a fixed "Bit Rate" set-
ting has to be provided by the user to bypass the software's estimation algorithm.
13.6.2 Custom: Manchester / NRZ configuration
If you need information on how to get started with configuring the custom serial bus
setup, see Chapter 13.6.2.6, "Configuring custom Manchester / NRZ signals",
on page
566. Otherwise proceed with the configuration settings.
13.6.2.1
Custom: Manchester / NRZ configuration settings
Access: [Bus] > "Custom" > "Setup" tab
Make sure that the tab of the correct serial bus is selected.
Figure 13-11: Coding standard selection in the serial bus protocol configuration dialog
See also: Chapter 13.1.1, "Setup - general settings", on page
485
Coding Standard
T
o define the coding of the custom serial bus to be analyzed, select one of the follow-
ing standards:
Custom: Manchester / NRZ (option R&S RT
O6-K510)