R&S RTO6 - 13.19.5.2 1000 BASE-T1 search results

Protocol analysis
R&S
®
RTO6
811User Manual 1801.6687.02 ─ 05
Remote command:
SEARch:
TRIGger:TBTO:
ERRor:FEC on page 2138
CRC error ← Errors
Searches for a frame that has a mismatch of the Cyclic Redundancy Check (CRC)
value between the transmitting and receiving device.
Remote command:
SEARch:TRIGger:TBTO:ERRor:CRC on page 2138
Out of range error ← Errors
Searches for values that are out of range. This can be, for example a preamble error,
or invalid symbols in control blocks.
Remote command:
SEARch:TRIGger:TBTO:ERRor:OOR on page 2138
Zero terrnary symbol ← Errors
Searches for zero ternary symbol pairs (0-0).
Remote command:
SEARch:TRIGger:TBTO:ERRor:ZERO on page 2139
13.19.5.2 1000BASE-T1 search results
To get search results, "Enable" the search. You can minimize, shift or close the search
dialog.
The search results are listed in the search result table and marked in the waveform by
blue lines.
For an introduction to search results, see:
●
Chapter 11.1.2, "Search results", on page 420
●
Chapter 11.4.2, "Display zoom settings", on page 440
Remote commands:
●
SEARch:RESult:TBTO:FCOunt? on page 2142
●
SEARch:RESult:TBTO:FRAMe<m>:TYPE? on page 2146
●
SEARch:RESult:TBTO:FRAMe<m>:STATe? on page 2145
●
SEARch:RESult:TBTO:FRAMe<m>:STARt? on page 2145
●
SEARch:RESult:TBTO:FRAMe<m>:STOP? on page 2145
●
SEARch:RESult:TBTO:FRAMe<m>:DESTaddress? on page 2142
●
SEARch:RESult:TBTO:FRAMe<m>:SRCaddress? on page 2144
●
SEARch:RESult:TBTO:FRAMe<m>:DATA? on page 2142
●
SEARch:RESult:TBTO:FRAMe<m>:CRC? on page 2142
●
SEARch:RESult:TBTO:FRAMe<m>:NUMWords? on page 2144
●
SEARch:RESult:TBTO:FRAMe<m>:FTYPe? on page 2143
●
SEARch:RESult:TBTO:FRAMe<m>:DSYMbol? on page 2143
Ethernet 1000BASE-T1 (option R&S R
T
O6-K560)