R&S RTO6 - Page 810

Protocol analysis
R&S
®
RTO6
810User Manual 1801.6687.02 ─ 05
"Data Min/Data"
Defines the bit pattern of the data pattern.
In binary format, use the following characters: 1; 0; or X (do not care).
T
o enter the pattern in other formats use the bit pattern editor
, see
Chapter 13.1.7, "Bit pattern editor", on page 493.
"Data Max"
The second data pattern is required to specify a range with conditions
"In range" and "Out of range".
Remote command:
SEARch:TRIGger:TBTO:
DATA:DCONdition on page 2136
SEARch:TRIGger:TBTO:DATA:DMIN on page 2137
SEARch:TRIGger:TBTO:DATA:DMAX on page 2136
Index
Sets the specified value or range within this series of data that is considered for the
search. The index setup consists of the condition and one or two index values.
"Condition"
Defines the operator to set a specific index, e.g. "Equal" or a range.
"Index Min/Index"
Defines the bit pattern of the index pattern.
In binary format, use the following characters: 1; 0; or X (do not care).
To enter the pattern in other formats use the bit pattern editor
, see
Chapter 13.1.7, "Bit pattern editor", on page 493.
"Index Max"
The second index pattern is required to specify a range with condi-
tions "In range".
Remote command:
SEARch:TRIGger:TBTO:
DATA:ICONdition on page 2137
SEARch:TRIGger:TBTO:DATA:IMIN on page 2138
SEARch:TRIGger:TBTO:DATA:IMAX on page 2137
Errors
Sets the type of error events to be searched for.
RS-FEC error ← Errors
Searches for RS-FEC errors.
Ethernet 1000BASE-T1 (option R&S RT
O6-K560)