Remote control commands
R&S
®
RTO6
1839User Manual 1801.6687.02 ─ 05
BUS<m>:LIN:STANdard <Standard>
Selects the version of the LIN standard.
See also: "LIN standard
"
on page 606
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<Standard> V1X | V2X | J2602 | AUTO
*RST: AUTO
24.17.9.2 Trigger
The trigger suf
fix <m> is always 1 and can be omitted. It selects the trigger event: Only
the A-trigger is available for triggering on serial buses.
To trigger on a serial bus, make sure that:
●
TRIGger<m>:SOURce[:SELect] is set to SBUS.
●
The sources of the serial bus are channel signals: use BUS<m>:...:SOURce
commands.
●
Decoding is enabled: BUS<m>[:STATe] is set to ON.
TRIGger<m>:LIN:TYPE................................................................................................1839
TRIGger<m>:LIN:ICONdition.........................................................................................1840
TRIGger<m>:LIN:IMIN..................................................................................................1841
TRIGger<m>:LIN:IMAX.................................................................................................1841
TRIGger<m>:LIN:DCONdition....................................................................................... 1841
TRIGger<m>:LIN:DMIN................................................................................................ 1841
TRIGger<m>:LIN:DMAX............................................................................................... 1841
TRIGger<m>:LIN:BORDer............................................................................................ 1842
TRIGger<m>:LIN:DLECondition.....................................................................................1842
TRIGger<m>:LIN:DLENgth........................................................................................... 1842
TRIGger<m>:LIN:IDOR<n>:ENABle...............................................................................1843
TRIGger<m>:LIN:IDOR<n>[:VALue]...............................................................................1843
TRIGger<m>:LIN:SYERror............................................................................................1843
TRIGger<m>:LIN:IPERror.............................................................................................1843
TRIGger<m>:LIN:CHKSerror.........................................................................................1844
TRIGger<m>:LIN:ERRPattern....................................................................................... 1844
TRIGger<m>:LIN:CRCDatalen...................................................................................... 1844
TRIGger<m>:LIN:STANdard..........................................................................................1845
TRIGger<m>:LIN:TYPE <Type>
Selects the trigger type for LIN analysis.
See: "Trigger type" on page 611.
Parameters:
<Type> SYNC | ID | IDOR | IDDT | WKFR | ERRC
Protocols
To Next Page
Loading...
