Protocol analysis
R&S
®
RTO6
887User Manual 1801.6687.02 ─ 05
For general information on how to handle the search functionality, see Chapter 1
1,
"Search functions", on page
419.
13.23.5.1 D-PHY search setup
Access: [Bus] > "Shortcuts" tab > "Setup search"
Type
Searches for the selected D-PHY type.
Remote command:
SEARch:TRIGger:DPHY:
TYPE on page 2261
HS Start of Packet ← Type
Searches for a transmission start of a high-speed packet.
HS End of Packet ← Type
Searches for a transmission end of a high-speed packet.
HS Packet Header ← Type
Searches for a packet header of a high-speed package. The header consists of a data
identifier (containing the Virtual Channel and the Data Type) and a Word Count/ Data.
You can specify the values each part of the packet header.
HS Data ← Type
Searches for a specified high-speed data.
LP Escape Mode ← Type
Searches for an escape mode event.
LP Lane Turnaround ← Type
Searches for a low-power turnaround, a reversion of the transmission direction.
LP HS Request ← Type
Searches for a high-speed request.
Virtual Channel
Searches for a specific virtual channel, an independent data stream for up to four
peripherals.
D-PHY (option R&S R
T
O6-K580)
To Next Page
Loading...
