Protocol analysis
R&S
®
RTO6
962User Manual 1801.6687.02 ─ 05
"CRC16 error"
Searches for 16-bit cyclic redundancy check (CRC) errors.
"LCRC error"
Searches for link cyclic redundancy check (LCRC) errors.
"ECRC error"
Searches for end-to-end cyclic redundancy checksum (ECRC) errors.
"Invalid sym-
bol"
Searches for invalid symbol errors.
"Disparity
error"
Searches for disparity errors.
Remote command:
SEARch:TRIGger:PCIE:
ERRC:CRC on page 2373
SEARch:TRIGger:PCIE:ERRC:DISP on page 2374
SEARch:TRIGger:PCIE:ERRC:ECRC on page 2374
SEARch:TRIGger:PCIE:ERRC:INVP on page 2374
SEARch:TRIGger:PCIE:ERRC:LCRC on page 2374
13.26.6.2 PCIe Gen 1/2 search results
To get search results, "Enable" the search. You can minimize, shift or close the search
dialog.
The search results are listed in the search result table and marked in the waveform by
blue lines.
For an introduction to search results, see:
●
Chapter 11.1.2, "Search results", on page 420
●
Chapter 11.4.2, "Display zoom settings", on page 440
The results of the search are the same as for decoding, see Chapter 13.27.3, "DDR
decode results", on page 971.
PCIe (option R&S RT
O6-K72)
To Next Page
Loading...
