Protocol analysis
R&S
®
RTO6
981User Manual 1801.6687.02 ─ 05
Remote command:
EYE<m>:
QUALify:GATE[:
STATe] on page 2410
EYE<m>:QUALify:GATE:COUPling on page 2410
EYE<m>:QUALify:GATE:MODE on page 2410
EYE<m>:QUALify:GATE:ABSolute:STARt on page 2411
EYE<m>:QUALify:GATE:ABSolute:STOP on page 2411
EYE<m>:QUALify:GATE:RELative:STARt on page 2411
EYE<m>:QUALify:GATE:RELative:STOP on page 2411
EYE<m>:QUALify:GATE:CURSor on page 2412
EYE<m>:QUALify:GATE:ZDIagram on page 2412
Signal
Sets a waveform-based qualification for the eye generation. The voltage level of a
waveform is compared with a threshold, and only if this condition is fulfilled, the slices
contribute to the eye generation.
State ← Signal
Applies the signal qualification.
Remote command:
EYE<m>:QUALify:SIGNal[:STATe] on page 2412
Source ← Signal
Selects the waveform to be compared.
Remote command:
EYE<m>:QUALify:SIGNal:SOURce on page 2413
Condition ← Signal
Selects the comparison condition for the waveform.
Remote command:
EYE<m>:QUALify:SIGNal:CONDition on page 2413
Vertical reference level ← Signal
Selects the threshold. You can use the lower, middle, or upper reference level. These
levels are the reference levels that are defined for measurements.
See Chapter 8.2.4, "Reference levels", on page 307.
Remote command:
EYE<m>:QUALify:SIGNal:LSELect on page 2413
Reference levels
Opens the reference level dialog. For details, see Chapter 8.2.4, "Reference levels",
on page 307.
13.27.4.4 Filter settings
Access: [App Cockpit]> "Analysis" > "DDR Eye" > "Filter" tab
Filter settings allow you to select waveform slices for eye generation dependent on the
bit status.
DDR (option R&S RT
O6-K91 )
To Next Page
Loading...
