Remote control commands
R&S
®
RTO6
2336User Manual 1801.6687.02 ─ 05
Parameters:
<IsSecondSync> ON | OFF
*RST: OFF
BUS<m>:EBTB:BITDetermi
Starts a software algorithm for the automatic determination of the bitrate.
Suffix:
<m>
.
1..4
Usage: Event
Asynchronous command
BUS<m>:EBTB:FAUToscale
Starts software algorithms for determining the signal threshold levels and bitrate.
Suffix:
<m>
.
1..4
Usage: Event
Asynchronous command
24.17.26.2 Trigger settings
The trigger suf
fix <m> is always 1 and can be omitted. It selects the trigger event: Only
the A-trigger is available for triggering on serial buses.
To trigger on a serial bus, make sure that:
●
TRIGger<m>:SOURce[:SELect] is set to SBUS.
●
The sources of the serial bus are channel signals: use BUS<m>:...:SOURce
commands.
●
Decoding is enabled: BUS<m>[:STATe] is set to ON.
TRIGger<m>:EBTB:DISParityerr................................................................................... 2336
TRIGger<m>:EBTB:DX.................................................................................................2337
TRIGger<m>:EBTB:DY.................................................................................................2337
TRIGger<m>:EBTB:EBPA.............................................................................................2337
TRIGger<m>:EBTB:GLITcherror....................................................................................2337
TRIGger<m>:EBTB:SSTYpe......................................................................................... 2337
TRIGger<m>:EBTB:SYME............................................................................................2338
TRIGger<m>:EBTB:SYMType.......................................................................................2338
TRIGger<m>:EBTB:TBPA.............................................................................................2338
TRIGger<m>:EBTB:STYPe...........................................................................................2338
TRIGger<m>:EBTB:UNK.............................................................................................. 2338
TRIGger<m>:EBTB:DISParityerr <DispError>
Defines, if a trigger on a disparity error is activated or not.
Protocols
To Next Page
Loading...
