Remote control commands
R&S
®
RTO6
1297User Manual 1801.6687.02 ─ 05
SYSTem:DEVice:ID?
Returns the instrument ID - that is the part number and the serial number
.
Return values:
<ID> String containing the part number and the serial number
Example:
1316.1000K24-001122-jT
Usage: Query only
DIAGnostic:SERVice:COMPutername <ComputerName>
The query returns the computer name that is currently defined. The computer name is
required when configuring a network.
The setting command changes the computer name. The change takes effect after the
next reboot of the computer
.
Parameters:
<ComputerName> Name string
Usage: Asynchronous command
24.7.2 Appearance
24.7.2.1 Colors appearance
DISPlay:COLor:SIGNal<m>:COLor................................................................................1297
DISPlay:COLor:
SIGNal<m>:ASSign...............................................................................1297
DISPlay:COLor:SIGNal<m>:USE...................................................................................1298
DISPlay:COLor:SIGNal<m>:COLor <Value>
Suffix:
<m>
.
1...218
W
aveform number
, see Chapter 24.4.1, "Waveform suffix",
on page 1279.
Parameters:
<Value> Decimal value of the ARGB color. Use the color dialog box on
the instrument to get the hex value of the color
, and convert the
hex value to a decimal value.
0 is fully transparent black.
4278190080 (dec) = FF000000 (hex) is opaque black.
4294967295 (dec) = FFFFFFFF (hex) is opaque white.
DISPlay:COLor:SIGNal<m>:ASSign <ColorTable>
Assigns the color table to the specified signal.
Instrument setup
To Next Page
Loading...
