Getting started
R&S
®
RTO6
46User Manual 1801.6687.02 ─ 05
1 = Vertical scale
2 = Offset
3 = Bandwidth
4 = Coupling
5 = Termination
If the signal bar contains many signal icons, and not all icons are visible, touch one of
the icons and scroll left or right until the required icon appears.
Y
ou can also switch of
f the signal bar: "Menu" > "Settings" > "Appearance" > "Diagram"
> "Show signal bar".
Histogram and histogram area
A histogram shows the frequency of occurrence of voltage or time values in a bar chart
directly in the diagram. The rectangular histogram area indicates the part of the wave-
form that is considered in the histogram. The vertical histogram counts the voltage val-
ues, and the horizontal histogram counts time values. You can switch between vertical
and horizontal mode, and modify the histogram area by dragging the rectangle as a
whole, by dragging its edges, or by setting exact positions.
3.3.2.2
Control elements on the touchscreen
The touchscreen provides everything you need to control the instrument, to analyze
waveforms, and to get measurement results. Figure 3-8 shows the control elements at
a glance.
Figure 3-8: Control elements on the touchscreen
Operating the instrument
To Next Page
Loading...
