Remote control commands
R&S
®
RTO6
2484User Manual 1801.6687.02 ─ 05
The command is available for the following measurement: skew delay and skew phase
(MEASurement<m>:
MAIN and/or
MEASurement<m>:ADDitional are set to mea-
surements SKWDelay | SKWPhase).
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1479.
Parameters:
<JitterSkewSlope> POSitive | NEGative | EITHer
*RST: POSitive
Usage: Asynchronous command
MEASurement<m>:JITTer:SKWRelation <JittskwRelt>
Sets the edge of the second waveform relative to the first waveform.
The command is available for the following measurements: skew delay and skew
phase (MEASurement<m>:
MAIN
and/or MEASurement<m>:ADDitional are set to
measurements SKWDelay | SKWPhase).
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1479.
Parameters:
<JittskwRelt>
MATChing | INVerse
MA
TChing
Measures from positive to positive edge or from negative to neg-
ative edge.
INV
erse
Measures from positive to negative edge or from negative to
positive edge.
*RST: MATChing
Usage: Asynchronous command
24.22.2 Advanced jitter and noise(option R&S RTO6-K133)/(option
R&S
RTO6-K134)
This chapter contains all remote commands to set up the advanced jitter and advanced
noise analysis.
Selection of the advanced jitter measurement: ADVJitter<m>
With R&S RTO6, you can configure up to two simultaneous advanced jitter measure-
ments. In manual operation, they are represented by subtabs "JA1" and "JA2" in the
Jitter analysis and clock data recovery
To Next Page
Loading...
