R&S RTO6 - Page 1483

Remote control commands
R&S
®
RTO6
1483User Manual 1801.6687.02 ─ 05
JITTer
Jitter measurements, available if one of the jitter options is
installed.
EYEJitter
Eye diagram measurements
SPECtrum
Spectrum measurements
HISTogram
Histogram measurements
PROT
ocol
Protocol measurements
OPTical
Optical measurements
*RST: AMPTime
Example: See "Creating and reading histograms" on page 1263
Usage: Asynchronous command
MEASurement<m>:
MAIN <MeasType>
Defines the measurement that is used as a source for math calculations and result
analysis. This measurement is mandatory in the measurement group. Further mea-
surements are added to the measurement group with MEASurement<m>:
ADDitional.
Suffix:
<m>
.
1..10
See
"Selection of the measurement group: MEASurement<m>"
on page 1479.
Parameters:
<MeasT
ype> Amplitude/time measurements
HIGH | LOW | AMPLitude | MAXimum | MINimum | PDELta |
MEAN | RMS | STDDev | POVershoot | NOV
ershoot | AREA |
RTIMe | FTIMe | PPULse | NPULse | PERiod | FREQuency |
PDCYcle | NDCYcle | CYCarea | CYCMean | CYCRms |
CYCStddev | PULCnt | DELay | PHASe | BWIDth | PSWitching |
NSWitching | PULSetrain | EDGecount | SHT | SHR | DTOTrig-
ger | PROBemeter | SLERising | SLEFalling | ATAR
See Chapter 24.12.3, "Amplitude/time measurements",
on page 1489.
*RST value for amplitude/time measurements: AMPLitude.
Jitter measurements
CCJitter | NCJitter | CCWidth | CCDutycycle | TIE | UINTerval |
DRATe | SKWDelay | SKWPhase
Only available if option R&S RTO6-K12 is installed. See Chap-
ter 24.22.1, "Jitter measurements (option R&S RTO6-K12)",
on page 2479.
Automatic measurements