Remote control commands
R&S
®
RTO6
1832User Manual 1801.6687.02 ─ 05
Return values:
<FrameType> DATA | REMote | ERR | OVLD
*RST: DATA
Usage: Query only
24.17.8.6 Symbolic trigger, decode and search
● Symbolic trigger..................................................................................................
1832
● Symbolic decode results..................................................................................... 1833
● Symbolic search..................................................................................................1834
Symbolic trigger
TRIGger<m>:CAN:SYMBolic:MSGValue........................................................................ 1832
TRIGger<m>:CAN:SYMBolic:TSIGnals.......................................................................... 1832
TRIGger<m>:CAN:SYMBolic:SIGValue.......................................................................... 1832
TRIGger<m>:CAN:SYMBolic:DMAX.............................................................................. 1833
TRIGger<m>:CAN:SYMBolic:DMIN............................................................................... 1833
TRIGger<m>:CAN:SYMBolic:SGEValue.........................................................................1833
TRIGger<m>:CAN:SYMBolic:MSGValue <MessageName>
Sets the message to be triggered or searched for.
The setting is used by symbolic trigger and symbolic search. Thus, you always trigger
on and search for the same message if symbolic trigger and symbolic search is used at
the same time.
See also: SEARch:TRIGger:CAN:SYMBolic:MSGValue on page 1835
Parameters:
<MessageName> String with the symbolic message name
TRIGger<m>:CAN:SYMBolic:TSIGnals <TriggerOnSignal>
Enables the trigger on a specific signal value that is part of the selected message.
Parameters:
<T
riggerOnSignal> ON | OFF
*RST: OFF
TRIGger<m>:CAN:SYMBolic:SIGValue <SignalName>
Sets the signal name to be triggered or searched for.
The setting is used by symbolic trigger and symbolic search. Thus, you always trigger
on and search for the same signal if symbolic trigger and symbolic search is used at
the same time.
See also:
SEARch:TRIGger:CAN:SYMBolic:SIGValue on page 1835
Protocols
To Next Page
Loading...
