R&S RTO6 - Page 1835

Remote control commands
R&S
®
RTO6
1835User Manual 1801.6687.02 ─ 05
Parameters for setting and query:
<SearchName> String that contains the search definition name
SEARch:TRIGger:CAN:SYMBolic:MSGValue <SearchName>, <MessageName>
SEARch:TRIGger:CAN:
SYMBolic:
MSGValue? <SearchName>
Sets the message to be triggered or searched for.
The setting is used by symbolic trigger and symbolic search. Thus, you always trigger
on and search for the same message if symbolic trigger and symbolic search is used at
the same time.
See also: TRIGger<m>:CAN:SYMBolic:MSGValue on page 1832
Parameters:
<MessageName> String that contains the symbolic message name
Parameters for setting and query:
<SearchName> String that contains the search definition name
Example:
SEARch:TRIGger:CAN:SYMBolic:MSGValue "Search1","EngineData"
SEARch:TRIGger:CAN:SYMBolic:SSIGnals <SearchName>,<SymbolicSearch>
SEARch:TRIGger:CAN:SYMBolic:
SSIGnals? <SearchName>
Enables the search for symbolic values if DBC label list file is loaded and applied.
Symbolic search disables all other search criteria.
Parameters:
<SymbolicSearch> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName> String that contains the search definition name
SEARch:TRIGger:CAN:SYMBolic:SIGValue <SearchName>, <SignalName>
SEARch:TRIGger:CAN:SYMBolic:
SIGValue? <SearchName>
Sets the signal name to be triggered or searched for.
The setting is used by symbolic trigger and symbolic search. Thus, you always trigger
on and search for the same signal if symbolic trigger and symbolic search is used at
the same time.
See also: TRIGger<m>:CAN:SYMBolic:SIGValue on page 1832
Parameters:
<SignalName> String that contains the symbolic signal name
Parameters for setting and query:
<SearchName> String that contains the search definition name
Example:
SEARch:TRIGger:CAN:SYMBolic:SIGValue "Search1","EngForce"
Protocols