R&S RTO6 - 24.17.24.2 D-PHY trigger

Remote control commands
R&S
®
RTO6
2248User Manual 1801.6687.02 ─ 05
Parameters:
<ThresholdHSDP3> Range: -1 to 1
Increment: 0.01
*RST: 0.2
Default unit: V
BUS<m>:DPHY:SMLanes <Active>
Enables the display of the results in multiple lanes.
Suffix:
<m>
.
1..4
Parameters:
<Active> ON | OFF
*RST: ON
24.17.24.2 D-PHY trigger
The trigger suffix <m> is always 1 and can be omitted. It selects the trigger event: Only
the A-trigger is available for triggering on serial buses.
T
o trigger on a serial bus, make sure that:
●
TRIGger<m>:SOURce[:SELect] is set to SBUS.
●
The sources of the serial bus are channel signals: use BUS<m>:...:SOURce
commands.
●
Decoding is enabled: BUS<m>[:STATe] is set to ON.
TRIGger<m>:DPHY:TYPE............................................................................................ 2249
TRIGger<m>:DPHY:DATA:CONDition............................................................................ 2249
TRIGger<m>:DPHY:DATA:MAX.....................................................................................2250
TRIGger<m>:DPHY:DATA:MIN......................................................................................2250
TRIGger<m>:DPHY:DIDX:CONDition.............................................................................2250
TRIGger<m>:DPHY:DIDX:MAX..................................................................................... 2250
TRIGger<m>:DPHY:DIDX:MIN...................................................................................... 2251
TRIGger<m>:DPHY:DTYPe:CONDition..........................................................................2251
TRIGger<m>:DPHY:DTYPe:MAX.................................................................................. 2251
TRIGger<m>:DPHY:DTYPe:MIN................................................................................... 2251
TRIGger<m>:DPHY:ESCMode:CONDition......................................................................2252
TRIGger<m>:DPHY:ESCMode:MAX..............................................................................2252
TRIGger<m>:DPHY:ESCMode:MIN............................................................................... 2252
TRIGger<m>:DPHY:ESDTa:CONDition.......................................................................... 2252
TRIGger<m>:DPHY:ESDTa:MAX...................................................................................2253
TRIGger<m>:DPHY:ESDTa:MIN....................................................................................2253
TRIGger<m>:DPHY:ESINdex:CONDition........................................................................2253
TRIGger<m>:DPHY:ESINdex:MAX................................................................................2254
TRIGger<m>:DPHY:ESINdex:MIN................................................................................. 2254
TRIGger<m>:DPHY:HSVC............................................................................................2254
Protocols