R&S RTO6 - 24.21.3 NFC trigger

Remote control commands
R&S
®
RTO6
2478User Manual 1801.6687.02 ─ 05
Usage: Query only
24.21.3 NFC trigger
TRIGger<m>:
NFC:TECHnology.....................................................................................
2478
TRIGger<m>:NFC:BITRate...........................................................................................2478
TRIGger<m>:NFC:EVENt............................................................................................. 2478
TRIGger<m>:NFC:TECHnology <Technology>
Selects the NFC technology, the communication protocol used by the input signal.
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
Parameters:
<Technology> NFCA | NFCB | NFCF
*RST: NFCA
Usage: Asynchronous command
TRIGger<m>:NFC:BITRate <Bitrate>
Sets the bit rate of the signal. For NFC-A and NFC-B, the bit rate is always 106 kBit
per second. For NFC-F, the bit rate can be either 212 or 424 kBit per second.
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
Parameters:
<Bitrate> KBPS106 | KBPS212 | KBPS424
*RST
: KBPS106
Usage: Asynchronous command
TRIGger<m>:NFC:EVENt <Event>
Sets the event to be triggered on.
Suffix:
<m>
.
1..3
Event in a trigger sequence: 1 = A-event only
Parameters:
<Event> ALL | SEN | ALLB | SENB | SOS48 | SOS96
ALL | SEN
ALL_REQ and SENS_REQ commands (polling requests), only
with NFC-A technology
I/Q software interface (option R&S RT
O6-K11)