Remote control commands
R&S
®
RTO6
1735User Manual 1801.6687.02 ─ 05
24.17.5.3 Decode results
BUS<m>:UAR
T
:WORD<n>:RXValue?............................................................................1735
BUS<m>:UART:WORD<n>:TXValue?............................................................................ 1735
BUS<m>:UART:WORD<n>:BITRate?............................................................................ 1735
BUS<m>:UART:WORD<n>:COUNt?..............................................................................1735
BUS<m>:UART:WORD<n>:SOURce?............................................................................1736
BUS<m>:UART:WORD<n>:STARt?............................................................................... 1736
BUS<m>:UART:WORD<n>:STATe?............................................................................... 1736
BUS<m>:UART:WORD<n>:RXValue?
BUS<m>:UART:WORD<n>:TXValue?
Returns the value of the specified word on the Rx line or Tx line, respectively.
Suffix:
<m>
.
1..4
Selects the serial bus.
<n> *
Selects the word.
Return values:
<Value> To set the value format, use FORMat:
BPATtern
.
The stated values for range, increment and reset are decimal
values.
Range: 0 to 511
*RST: 0
Usage: Query only
BUS<m>:UART:WORD<n>:BITRate?
Returns the primary bit rate.
Suffix:
<m>
.
1..4
Selects the serial bus.
<n> *
The suffix is irrelevant.
Return values:
<PrimaryBitRate>
Range: 0 to 100000000000
Increment: 1
*RST: 0
Default unit: bps
Usage: Query only
BUS<m>:UART:WORD<n>:COUNt?
Returns the number of words in the acquisition.
Protocols
To Next Page
Loading...
