R&S RTO6 - 24.8.13 High definition mode

Remote control commands
R&S
®
RTO6
1386User Manual 1801.6687.02 ─ 05
CALibration:SOURce:FREQuency <Frequency>
Frequency value and waveform type of the internal calibration source, which is output
at the [Aux Out]
connector
.
Parameters:
<Frequency> KHZ7900 | MHZ10 | KHZ15800 | MHZ31_25 | KHZ31600 |
KHZ63200 | GHZ1 | MHZ250MB | MHZ250mb | GHZ1_20DB |
MHZ62 | MHZ125 | MHZ250 | MHZ500 | KHZ505500 |
MHZ1R |
MHZ31R | MHZ31_25R | MHZ498S | MHZ1257_2S |
MHZ2491S | MHZ4060S | MHZ4350S | MHZ4810S |
MHZ4991S | MHZ5940S | MHZ10 | MHZ31_25 | MHZ250MB |
MHZ250mb | GHZ1_20DB | GHZ1
MHZ10
10 MHz square wave
MHZ31_25 | GHZ1 | MHZ250MB
31.25 MHz, 1 GHz, 250 MHz sine waves generated by the main-
board.
MHZ250MB = MHZ250mb
GHZ1_20DB
Clinched sine wave with indicated frequency, generated by the
frontend.
GHZ1
1 GHz sine wave generated by the mainboard.
*RST: GHZ1
Example:
CAL:SOUR:FREQ GHZ1
CAL:SOUR:
STAT ON
The commands activate the 1 GHz reference frequency.
Usage: Asynchronous command
CALibration:SOURce:STATe <State>
Defines the state of the internal calibration source.
Parameters:
<State> ON | OFF
*RST: OFF
Usage: Asynchronous command
24.8.13 High definition mode
HDEFinition:STATe.......................................................................................................1387
HDEFinition:BWIDth.....................................................................................................1387
HDEFinition:RESolution?.............................................................................................. 1387
FORMat:BORDer.........................................................................................................1387
Acquisition and setup