R&S RTO6 - 19.5.3.3 Switching loss settings

Power analysis (option R&S RTO6-K31)
R&S
®
RT
O6
1178User Manual 1801.6687.02 ─ 05
10. Tap "Execute".
On the screen you can see the measurement waveforms of the current, the voltage
and the power
. Also, the result box with numeric measurement results is shown.
For details, see
Chapter 19.5.3.1, "Switching loss results", on page 1175.
19.5.3.3 Switching loss settings
In the "Channels" tab, you set the current source and the voltage source, see also:
Chapter 19.2.1, "Channels tab", on page 1134.
In the "Settings" tab, you configure the switching loss parameters and display settings.
Switching frequency > Auto
Enables the measurements of the switching frequency. If disabled you can enter the
value of the switching frequency
.
Remote command:
POWer:SWITching:SWIFrequency on page 2544
POWer:SWITching:SWIT on page 2545
Turn on
Enables the measurements during the turn on period.
Remote command:
POWer:SWITching:TON on page 2545
Power path