R&S RTO6 - Page 2544

Remote control commands
R&S
®
RTO6
2544User Manual 1801.6687.02 ─ 05
POWer:SWITching:GATE:TOFF:STOP...........................................................................
2545
POW
er:SWITching:GATE:TON:STARt............................................................................2545
POWer:SWITching:GATE:TON:STOP............................................................................ 2545
POWer:SWITching:RESult:ENERgy:ACTual?..................................................................2545
POWer:SWITching:RESult:ENERgy:AVG?......................................................................2545
POWer:SWITching:RESult:ENERgy:EVTCount?............................................................. 2545
POWer:SWITching:RESult:ENERgy:NPEak?.................................................................. 2545
POWer:SWITching:RESult:ENERgy:PPEak?.................................................................. 2545
POWer:SWITching:RESult:ENERgy:RMS?..................................................................... 2545
POWer:SWITching:RESult:ENERgy:STDDev?................................................................ 2545
POWer:SWITching:RESult:ENERgy:WFMCount?............................................................2545
POWer:SWITching:RESult:POWer:ACTual?................................................................... 2546
POWer:SWITching:RESult:POWer:AVG?........................................................................2546
POWer:SWITching:RESult:POWer:EVTCount?............................................................... 2546
POWer:SWITching:RESult:POWer:NPEak?.................................................................... 2546
POWer:SWITching:RESult:POWer:PPEak?.................................................................... 2546
POWer:SWITching:RESult:POWer:RMS?.......................................................................2546
POWer:SWITching:RESult:POWer:STDDev?..................................................................2546
POWer:SWITching:RESult:POWer:WFMCount?..............................................................2546
POWer:SWITching:AUTO <Autoscale>
Selects the scaling for the display of the results.
Parameters:
<Autoscale> AUTO | MANUAL
*RST: MANUAL
POWer:SWITching:EXECute
Starts the switching loss measurement.
Usage: Event
Asynchronous command
POWer:SWITching:REPort:ADD
Adds the result to the report list.
Usage: Event
POWer:SWITching:SWIFrequency <SwitchingFreq>
Sets the switching frequency.
Parameters:
<SwitchingFreq>
Range: 1 to 500E+9
Increment: 1000
*RST: 10E+6
Default unit: Hz
Power analysis (option R&S RT
O6-K31)