Protocol analysis
R&S
®
RTO6
671User Manual 1801.6687.02 ─ 05
7. Enter the "Threshold" and the "Hysteresis".
8.
Enable "Decode"
.
13.11.3 CXPI trigger
13.11.3.1 CXPI trigger settings
Access: [Bus] > "Shortcuts" tab > "Setup trigger"
Make sure that:
●
In the [Bus] > "Setup" tab:
– The correct "Protocol" is selected.
– The data sources of the serial bus are channel signals.
●
In the "Trigger" > "Setup" tab:
– The "Trigger on" = "Single event"
– The trigger "Source" = "Serial bus".
– The correct "Serial bus" is selected.
Trigger type
Selects the trigger type for CXPI analysis.
Remote command:
TRIGger<m>:CXPI:
TYPE on page 1940
Frame Start ← Trigger type
Triggers on a frame start.
CXPI (option R&S RT
O6-K520)
To Next Page
Loading...
