R&S RTO6 - 11.4.3 Configuring the search results presentation

Search functions
R&S
®
RTO6
441User Manual 1801.6687.02 ─ 05
SEARch:RESDiagram:VERT:ABSolute:SPAN on page
1636
SEARch:
RESDiagram:VERT:RELative:SPAN on page 1637
X mode
Defines whether absolute or relative values are used to specify the x-axis values.
Remote command:
LAYout:ZOOM:HORZ:MODE on page 1439
SEARch:RESDiagram:HORZ:MODE on page 1635
X position
Defines the x-value of the centerpoint of the zoom area.
Remote command:
LAYout:ZOOM:HORZ:ABSolute:POSition on page 1439
LAYout:ZOOM:HORZ:RELative:POSition on page 1441
SEARch:RESDiagram:HORZ:ABSolute:POSition on page 1634
SEARch:RESDiagram:HORZ:RELative:POSition on page 1635
X range
Defines the width of the zoom area.
Remote command:
LAYout:ZOOM:HORZ:ABSolute:SPAN on page 1440
LAYout:ZOOM:HORZ:RELative:SPAN on page 1441
SEARch:RESDiagram:HORZ:ABSolute:SPAN on page 1635
SEARch:RESDiagram:HORZ:RELative:SPAN on page 1636
11.4.3 Configuring the search results presentation
Initially, the "Search Results" box is displayed in front of the other diagrams or as result
icon on the signal bar. This depends on the default setting in the "Diagram Layout" tab.
Alternatively, you can display it in its own area on the screen, like any other diagram.
For details, see Chapter 3.3.7, "Displaying results", on page 58.
To configure the result tables
1. Open the search dialog: "Menu" > "Apps" > "Analysis" tab > "Search".
2. Select the tab for the search you want to configure.
3. Select the "Display" tab.
4. Select "Show result table" to display the "Search Results" box.
5. Select the sort mode of the result table.
6. By default, the results are listed in descending order, i.e. the largest value at the
top. To change the sorting direction, enable "Sort ascending".
7. Define a maximum number of results to be displayed in the result table in the "Max.
result count" field.
Search display presentation