R&S RTO6 - Page 1441

Remote control commands
R&S
®
RTO6
1441User Manual 1801.6687.02 ─ 05
LAYout:ZOOM:HORZ:ABSolute:STOP <DiagramName>, <ZoomName>,<Stop>
LA
Y
out:ZOOM:HORZ:ABSolute:STOP? <DiagramName>, <ZoomName>
Defines the upper limit of the zoom area on the x-axis.
For numerical values, the input of a unit is not supported for this command.
Parameters:
<Stop> Range: -100E+24 to 100E+24
Increment: 0.01
*RST: 0.01
Parameters for setting and query:
<DiagramName> Name of the diagram on which the zoom area is based.
<ZoomName> Name of the zoom diagram
Usage: Asynchronous command
LAYout:ZOOM:HORZ:RELative:POSition <DiagramName>,
<ZoomName>,<RelPosi>
LAY
out:ZOOM:HORZ:RELative:POSition? <DiagramName>, <ZoomName>
Defines the x-value of the centerpoint of the zoom area.
Parameters:
<RelPosi> Relative position of the centerpoint (x-value)
Range: 0 to 100
Increment: 0.1
*RST: 100
Default unit: %
Parameters for setting and query:
<DiagramName> Name of the diagram on which the zoom area is based.
<ZoomName> Name of the zoom diagram
Example: See Chapter 24.3.1.2, "Creating zoom diagrams", on page 1261
Usage: Asynchronous command
LAYout:ZOOM:HORZ:RELative:SPAN <DiagramName>,
<ZoomName>,<RelativeSpan>
LA
Y
out:ZOOM:HORZ:RELative:SPAN? <DiagramName>, <ZoomName>
Defines the width of the zoom area.
Parameters:
<RelativeSpan> Range: 1E-15 to 100
Increment: 0.1
*RST: 1
Default unit: %
Parameters for setting and query:
<DiagramName> Name of the diagram on which the zoom area is based.
Waveform analysis