R&S RTO6 - Qualify: gate settings

Remote control commands
R&S
®
RTO6
2410User Manual 1801.6687.02 ─ 05
Parameters:
<Time> Range: 0.05 to 50
Increment: 0.05
*RST: 0.05
Default unit: s
Usage: Asynchronous command
Qualify: gate settings
EYE<m>:QUALify:GATE[:
STATe]...................................................................................2410
EYE<m>:QUALify:GATE:COUPling................................................................................2410
EYE<m>:QUALify:GATE:MODE.................................................................................... 2410
EYE<m>:QUALify:GATE:ABSolute:STARt.......................................................................2411
EYE<m>:QUALify:GATE:ABSolute:STOP....................................................................... 2411
EYE<m>:QUALify:GATE:RELative:STARt.......................................................................2411
EYE<m>:QUALify:GATE:RELative:STOP....................................................................... 2411
EYE<m>:QUALify:GATE:CURSor..................................................................................2412
EYE<m>:QUALify:GATE:ZDIagram................................................................................2412
EYE<m>:QUALify:GATE[:STATe] <State>
Enables the gate.
Suffix:
<m>
.
1..4
Parameters:
<State> ON | OFF
*RST: OFF
Usage: Asynchronous command
EYE<m>:QUALify:GATE:COUPling <CouplingMode>
Sets the gate coupling. To use cursor lines or zoom areas as gate limits, the cursor or
zoom must be defined before.
Suffix:
<m>
.
1..4
Parameters:
<CouplingMode>
NONE | CURSor | ZOOM
*RST: NONE
Usage: Asynchronous command
EYE<m>:QUALify:GATE:MODE <Mode>
Defines whether the gate limit is defined in absolute or relative values when no gate
coupling is set.
Protocols