EasyManua.ls Logo

R&S RTO6 - 24.24.1 Measurement setup

R&S RTO6
2677 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Remote control commands
R&S
®
RTO6
2559User Manual 1801.6687.02 ─ 05
Chapter 24.3, "Programming examples", on page 1259
Measurement setup............................................................................................
2559
Save and load the deembedding setup.............................................................. 2561
Components........................................................................................................2562
Responses.......................................................................................................... 2568
24.24.1 Measurement setup
DEEMbedding<m>[:STATe]...........................................................................................2559
DEEMbedding<m>:ADD............................................................................................... 2559
DEEMbedding<m>:REMove..........................................................................................2560
DEEMbedding<m>:CCOunt?........................................................................................ 2560
DEEMbedding<m>:BANDwidth..................................................................................... 2560
DEEMbedding<m>:CMPDelay...................................................................................... 2561
DEEMbedding<m>:PRESet.......................................................................................... 2561
DEEMbedding<m>[:STATe] <State>
Activates the deembedding - the correction of parasitic effects of the measurement
setup on the measured signal.
Suffix:
<m>
.
1..4
Selects the channel that is configured for deembedding.
Parameters:
<State> ON | OFF
*RST: OFF
Usage: Asynchronous command
DEEMbedding<m>:ADD <Index>, [<Type>]
Adds a component to the measurement setup.
Suffix:
<m>
.
1..4
Selects the channel that is configured for deembedding.
Setting parameters:
<Index> Defines the place of the component in the measurement path.
The DUT is always the first component (index = 1), the probe or
input is the last component.
<T
ype> PROBe | FIXTure | CABLe | DUT | ADAPter | INPut | OTHer |
R
TZA10 | R
TZA16 | RTZA17 | PP | PC | COPRobes
RTZA10 | RTZA16 | RTZA17
SMA adapters and cable offered by Rohde & Schwarz
PP | PC
Proven probe, proven cable
Deembedding (option R&S RT
O6-K121)

Table of Contents

Other manuals for R&S RTO6

Related product manuals