Data and file management
R&S
®
RTO6
464User Manual 1801.6687.02 ─ 05
<value 1>
<value 2>
<...>
You can also select the format of the time stamp in the
"Acquire" > "History" dialog.
Remote command:
EXPort:WAVeform:TIMestamps on page 1654
Multiple acquisitions in one file
If enabled, allows you to save several or all history waveforms. Define the part of the
history to be exported using "Start acquisition" and "Stop acquisition".
If multiple acquisitions of one waveform are exported into a BIN file, the first acquisition
can be reloaded as reference waveform.
Remote command:
CHANnel<m>[:WAVeform<n>]:HISTory:STARt on page 1462
CHANnel<m>[:WAVeform<n>]:HISTory:STOP on page 1462
Start export
Starts the history replay and simultaneous saving.
Remote command:
CHANnel<m>[:WAVeform<n>]:HISTory:PLAY on page 1463
Save to file
Enter the filename to save the waveform to. Double-tap the filename to open the file
selection dialog box.
By default, the filename has the prefix "RefCurves_". You can define a pattern for auto-
matic naming in the "Autonaming" dialog, see Chapter 4.8.1, "Autonaming",
on page 104.
"Save"
Saves the waveform as a reference waveform in the selected file.
"Save As..."
Opens the file selection dialog box and saves the waveform to the
selected file. See also Chapter 12.5, "File selection dialog",
on page
482
".bin/.xml/.csv"
Selects the file format. Note that reference waveforms can be loaded
from
.bin files only.
See also:
Chapter 12.2.1, "Waveform export files", on page 453.
Remote command:
EXPort:WAVeform:NAME on page 1651
EXPort:WAVeform:SAVE on page 1651
12.2.2.3 Waveform logger settings
Access: "Menu" key >"Save/Recall" key > "Save" tab > "Waveform" > "Logger" tab.
Save and recall waveform data and results
To Next Page
Loading...
