Data and file management
R&S
®
RTO6
471User Manual 1801.6687.02 ─ 05
Measurement
Selects the measurement to be exported.
Remote command:
EXPort:
MEASurement:
SELect on page 1659
Source, Measurement scale
Displays the measurement settings source and scale.
Export type
You can export the result data of the long-term measurement, the measurement histo-
gram or the track.
To export the data, the required type must be enabled in the ""Menu" > "Measure" >
Plot" tab: "Long term > Enable", "Histogram > Enable" or "Track > Enable".
Remote command:
EXPort:MEASurement:TYPE on page 1659
Incidence
Sets the mode of exported histogram data: relative or absolute count of values. If rela-
tive values are exported, the sum of all values is 1, and the count of each value is set
in relation to the sum.
Remote command:
EXPort:HISTogram:INCidence on page 1656
Save to file
Enter the filename to save the measurement data to. Double-tap the filename to open
the file selection dialog box.
By default, the filename has the prefix "Measurement_".
You can define a pattern for automatic naming in the "Autonaming" tab, see Chap-
ter 4.8.1, "Autonaming", on page 104.
The default directory is:
C:\Users\Public\Documents\Rohde-Schwarz\RTO6\Measurements
"Save"
Saves the measurement data in the selected file.
"Save As..."
Opens the file selection dialog box and saves the measurement data
to the selected file. See also Chapter 12.5, "File selection dialog",
on page
482
".bin/.xml/.csv"
Selects the file format.
Remote command:
EXPort:HISTogram:
NAME on page 1657
EXPort:MEASurement:SAVE on page 1660
EXPort:MEASurement:DATA? on page 1660
12.2.6 Eyes
Access: "Menu" key >"Save/Recall" key > "Save" tab > "Eyes"
Save and recall waveform data and results
To Next Page
Loading...
