Protocol analysis
R&S
®
RTO6
919User Manual 1801.6687.02 ─ 05
This error means that the waveform violates the reserved field according to the specifi-
cation. For example, a DL_PDU_AFC frame requires that the two bits before and three
bits after the FSN field to be reserved and set as 0. If the waveform carries 1 in these
positions instead, it is marked as this error
.
Remote command:
SEARch:
TRIGger:MPHY:ERRor:REServed on page 2314
LCC Command Error ← Errors
Searches for LCC command error.
This error is marked when the Command field in the LCC packet is not a known com-
mand defined in the specification.
Remote command:
SEARch:TRIGger:MPHY:ERRor:LCMD on page 2314
8b10b Symbol Error ← Errors
Searches for 8b10b symbol error.
For example, some of the 10-bit combinations that do not map to 8-bit according to the
specification are invalid 10-bit and therefore marked as this error.
Remote command:
SEARch:TRIGger:MPHY:ERRor:SYMBol on page 2314
Unknown Unipro Frame ← Errors
Searches for unidentified UniPro frame error. This error is marked when the end mark
on Unipro packets is undetected.
Remote command:
SEARch:TRIGger:MPHY:ERRor:UNKNown on page 2314
Length Error ← Errors
Searches for frames that violate the length according to the specification.
Remote command:
SEARch:TRIGger:MPHY:ERRor:LENGth on page 2315
13.24.5.2 M-PHY search results
To get search results, "Enable" the search. You can minimize, shift or close the search
dialog.
The search results are listed in the search result table and marked in the waveform by
blue lines.
For an introduction to search results, see:
●
Chapter 11.1.2, "Search results", on page 420
●
Chapter 11.4.2, "Display zoom settings", on page 440
Remote commands:
●
SEARch:RESult:MPHY:FCOunt? on page 2315
●
SEARch:RESult:MPHY:FRAMe<m>:CCOunt? on page 2315
M-PHY and USB SSIC (option R&S R
T
O6-K580 and K570)
To Next Page
Loading...
