Protocol analysis
R&S
®
RTO6
729User Manual 1801.6687.02 ─ 05
Bit rate
Defines the transmission speed setting for the data signal:
●
10BASE-T
: default bit rate 10 Mbps
●
100BASE-TX: default bit rate 125 Mbps
In both variants, the permitted bit rates range from 10 kbps to 150 Mbps. Switching the
variant adjusts the bit rate, independent of the previous setting.
Remote command:
BUS<m>:
ETHernet:BITRate on page 2019
Show thresholds
If enabled, the threshold levels are displayed in the diagram.
Remote command:
BUS<m>:THReshold on page 1671
13.15.2.2 Ethernet display settings
Access: [Bus] > "Display" tab.
For common display settings, see Chapter 13.1.3, "Display", on page 487
.
T
o enhance the decode possibilities of the Ethernet protocol, you can use an additional
setting in the "Display" tab: "Decode layer".
Ethernet Specific Label Settings
Label lists are protocol-specific. An Ethernet label file contains two values for each
identifier:
●
"Ethernet Header Display": the Ethernet header display value (e.g.
FF:FF:FF:FF:FF:FF/48)
●
"Symbolic label": user-defined symbolic name of the header, specifying its function
(e.g. BroadCast).
Ethernet 10BASE-T and 100BASE-TX (option R&S R
T
O6-K540)
To Next Page
Loading...
