Data and file management
R&S
®
RTO6
463User Manual 1801.6687.02 ─ 05
"Save As..."
Opens the file selection dialog box and saves the waveform to the
selected file. See also Chapter 12.5, "File selection dialog",
on page
482
".bin/.xml/.csv"
Selects the file format. Note that reference waveforms can be loaded
from
.bin files only.
See also:
Chapter 12.2.1, "Waveform export files", on page 453.
Remote command:
EXPort:WAVeform:
NAME on page 1651
EXPort:WAVeform:SAVE on page 1651
12.2.2.2 Waveform history settings
Access: "Menu" key >"Save/Recall" key > "Save" tab > "Waveform" > "History" tab.
In this dialog you can configure the export of the history waveform data to file. Select
the channels and scope in the "Setup"
tab.
Export history
Enables the history mode and the export of history waveforms to file.
Remote command:
CHANnel<m>[:WAVeform<n>]:HISTory[:STATe] on page 1461
Time stamps
If enabled, the relative timestamps of all history waveforms are written into the wave-
form data file at the beginning of each waveform record.
The following format is used:
<timestamp as double float of first acquisition>
<value 1>
<value 2>
<...>
<timestamp as double float of second acquisition>
Save and recall waveform data and results
To Next Page
Loading...
