Getting started
R&S
®
RTO6
58User Manual 1801.6687.02 ─ 05
Annotate
Defines a waveform label that names or explains the waveform. T
ap the icon and then
tap the waveform to be labeled. Enter the label text using the on-screen keyboard. The
text is shown in the same color as the waveform. If you tap the display background, the
label is assigned to the focused waveform. Y
ou can drag the label to another position.
Save Reference
Copies the selected source waveform with all its settings to the reference waveform. If
the acquisition is running, the reference waveform is a snapshot. You can configure up
to four reference waveforms.
T
ap the icon, and select the required reference waveform (R1 to R4) in the overlay
menu. Tap the waveform to be copied.
Save Waveform
Exports the waveform data to file using the settings defined in
"Menu" > "Save/Recall"
> "Save" tab > "W
aveform" > "Setup" tab.
The filename is created according to the autonaming pattern.
Tap the icon and then tap the waveform to be exported. If you tap the display back-
ground, the focused waveform is exported, or a multichannel export is performed if
configured.
Zone trigger
Defines a zone trigger
, which combines the trigger condition with the intersection or
non-intersection of one or more zones or masks.
T
ap the icon and then tap the corner points of the zone on the screen. Tap "Finish
zone". You can add more zones to the trigger condition.
Spectrogram (option R&S RTO6-K37)
Starts an FFT and the spectrogram. The FFT trace and the spectrogram are shown in
separate diagrams.
Tap the icon. Select the source in the sidebar
, or tap diagram with the waveform to be
transformed. The diagrams are created from the selected waveform.
Delete
Removes waveforms, measurements, zoom, histograms, mask segments and other
elements from the display.
T
ap the icon and then tap the element to be deleted, or the waveform to be switched
off.
3.3.7 Displaying results
The results of measurements, mask tests, searches, protocol decoding and others are
displayed immediately. There are several places to display the results:
●
In a table that is docked below the diagram (only for measurement and decode
results)
●
In a floating result box in front of the diagrams, which you can move on the display
Operating the instrument
To Next Page
Loading...
