R&S RTO6 - 24.23.5 Inrush current

Remote control commands
R&S
®
RTO6
2529User Manual 1801.6687.02 ─ 05
24.23.5 Inrush current
This measurement is a single shot measurement. T
o start the measurement, use the
RUNS command.
POW
er:INRush:ADD.................................................................................................... 2529
POWer:INRush:INSert..................................................................................................2529
POWer:INRush:REMove...............................................................................................2529
POWer:INRush:COUNt?...............................................................................................2529
POWer:INRush:EXECute..............................................................................................2530
POWer:INRush:GATE<m>:STARt..................................................................................2530
POWer:INRush:GATE<m>:STOP.................................................................................. 2530
POWer:INRush:GATE<m>:VALue..................................................................................2530
POWer:INRush:MAXCurrent......................................................................................... 2530
POWer:INRush:TRIGger...............................................................................................2530
POWer:INRush:REPort:ADD.........................................................................................2531
POWer:INRush:ADD
Adds a gate.
Usage: Event
POWer:INRush:INSert <GateIndex>
Inserts a gate.
Setting parameters:
<GateIndex>
Usage: Setting only
POWer:INRush:REMove <GateIndex>
Removes a gate
Setting parameters:
<GateIndex>
Usage: Setting only
POWer:INRush:COUNt?
Queiries the number of inrush current gates.
Return values:
<Count>
Usage: Query only
Power analysis (option R&S RT
O6-K31)