R&S RTO6 - 24.12.8.2 Histogram measurement

Remote control commands
R&S
®
RTO6
1527User Manual 1801.6687.02 ─ 05
Parameters:
<RelativeStop> Range: 0 to 100
Increment: 0.1
*RST: 100
Default unit: %
Parameters for setting and query:
<HistogramName>
Usage: Asynchronous command
LAYout:HISTogram:RESet <HistogramName>
Resets the values to begin a new histogram.
Setting parameters:
<HistogramName>
Usage: Setting only
Asynchronous command
LAYout:HISTogram:REMove <Name>
Removes the specified histogram.
Setting parameters:
<Name>
Usage: Setting only
Asynchronous command
24.12.8.2 Histogram measurement
This chapter lists commands to set up measurements on histograms.
Note that the R&S RT
O6 performs histogram measurements on the measurement that
is defined with MEASurement<m>:MAIN. Other measurements are not considered.
See also: "Creating and reading histograms" on page 1263.
The following table lists the <MeasType> parameter values with a short description.
In addition, the suffixes <n> for limit-check remote commands are listed.
For a detailed description, see Table 8-8.
Table 24-10: Histogram measurements
<MeasType>
parameter value
(remote control)
Measurement
(manual opera-
tion)
Description/Result Suffix
<n>
WCOunt Waveform count Number of acquisitions (waveforms) the histogram
is based on
1
WSAMples Waveform samples Number of samples from the most recent acquisition
included in the current histogram
2
Automatic measurements