R&S RTO6 - 24.17.4.5 SPI search results

Remote control commands
R&S
®
RTO6
1723User Manual 1801.6687.02 ─ 05
SEARch:TRIGger:SPI:DPTO <SearchName>,<DataPositionT
o>
SEARch:TRIGger:SPI:DPT
O? <SearchName>
Sets the the end value of a data postion range.
Parameters:
<DataPositionTo> Range: 1 to 32767
Increment: 1
*RST: 1
Parameters for setting and query:
<SearchName>
Firmware/software: FW 3.30
SEARch:TRIGger:SPI:PALignment <SearchName>,<DataAlignment>
SEARch:TRIGger:SPI:PALignment
? <SearchName>
Defines how the specified data pattern is searched.
Parameters:
<DataAlignment> WORD | BIT
WORD
The pattern is matched only at word boundaries.
BIT
Bit-by-bit: the pattern can start at any position in the message.
*RST: WORD
Parameters for setting and query:
<SearchName>
Usage: Asynchronous command
Firmware/software: FW 3.30
24.17.4.5 SPI search results
The search on decoded SPI data returns the same results as the queries for decode
results.
In search result commands, you must specify the <SearchName> parameter. It is a
string parameter that contains the search definition name.
The suf
fix FRAMe<m> indicates the frame index. The suffix WORD<n> indicates the
word index inside a frame-
For a description of the returned values, see the corresponding commands in Chap-
ter 24.17.4.3, "SPI decode results", on page 1715.
SEARch:RESult:SPI:FCOunt?.......................................................................................1724
SEARch:RESult:SPI:FRAMe<m>:COUNt?..................................................................... 1724
SEARch:RESult:SPI:FRAMe<m>:DATA?........................................................................1724
SEARch:RESult:SPI:FRAMe<m>:STARt?.......................................................................1724
SEARch:RESult:SPI:FRAMe<m>:STATus?.....................................................................1725
Protocols