Instrument setup
R&S
®
RTO6
92User Manual 1801.6687.02 ─ 05
Intensity
This value determines the strength of the waveform line in the diagram. Enter a per-
centage between 0 (not visible) and 100% (strong). The default value is 50%.
You can also use the
[Intensity] knob on the left side of the screen to adjust the wave-
form intensity directly.
Note: Use of color tables. The exact mapping of the cumulative value occurrences
according to the assigned color table is guaranteed only if the intensity is set to 50%.
All other intensity values falsify the mapping but can improve the visibility of the signal.
Remote command:
DISPlay:INTensity on page 1320
Waveform style
Select the style in which the waveform is displayed:
"Vectors"
The individual waveform points are connected by a line.
Define the strength of the line using the
[Intensity] knob.
"Dots"
Only the individual waveform points are displayed. W
aveform sample
points are the ADC sample points and additional interpolated points if
"Interpolated time" is used for resolution enhancement. T
o see the
dots of one waveform, perform one acquisition with [Single] and N=1
("Average count" = 1). During continuous acquisition, or a [Single]
acquisition with N > 1, the dots of multiple subsequent waveforms are
displayed on the screen, and the waveform looks like a line.
Consider also the "Interpolation" on page 128.
Remote command:
DISPlay:
DIAGram:
STYLe on page 1321
4.4.3 Backlight settings
Access: "Menu" > "Settings" > "Display" > "Backlight"
Display settings
To Next Page
Loading...
