R&S RTO6 - 24.8 Acquisition and setup

Remote control commands
R&S
®
RTO6
1324User Manual 1801.6687.02 ─ 05
DIAGnostic:SERVice:FWVersion?
Returns the firmware version that is currently installed on the instrument.
Return values:
<FirmwareVersion> Version string
Usage: Query only
Asynchronous command
DIAGnostic:SERVice:PARTnumber <Number>
Returns the part number (order number) of your instrument. This number is required to
order a new option, and in case of service.
Parameters:
<Number> Number string
Usage: Asynchronous command
DIAGnostic:SERVice:SERialnumber?
Returns the serial number of your instrument. This number is required to order a new
option, and in case of service.
Return values:
<SerialNumber> Number string
Usage: Query only
Asynchronous command
DIAGnostic:SERVice:CHANnelcount?
Queries the number of available channels.
Return values:
<ChannelCount> Range: 0 to 4
Increment: 1
*RST: 0
Usage: Query only
Asynchronous command
Firmware/software: V 2.00
24.8 Acquisition and setup
Some of the commands in the following chapter are asynchronous. An overlapping or
asynchronous command does not automatically finish executing before the next com-
mand starts executing. If overlapping commands must be executed in a defined order,
e.g. to avoid wrong measurement results, they must be serviced sequentially.
Acquisition and setup