Protocol analysis
R&S
®
RTO6
839User Manual 1801.6687.02 ─ 05
"Max"
Sets the end value of an ET range if "Condition" (SEARch:
TRIGger:
USB:TCONdition) is set to
INRange or OORange.
Remote command:
SEARch:TRIGger:USB:
WETCheck on page 2181
SEARch:TRIGger:USB:TCONdition on page 2179
SEARch:TRIGger:USB:TMIN on page 2179
SEARch:TRIGger:USB:TMAX on page 2180
13.20.5.2 USB 2.0 search results
To get search results, "Enable" the search. You can minimize, shift or close the search
dialog.
The search results are listed in the search result table and marked in the waveform by
blue lines.
For an introduction to search results, see:
●
Chapter 11.1.2, "Search results", on page 420
●
Chapter 11.4.2, "Display zoom settings", on page 440
Remote commands:
●
SEARch:RESult:USB:PCOunt? on page 2187
●
SEARch:RESult:USB:PACKet<m>:STATus? on page 2187
●
SEARch:RESult:USB:PACKet<m>:STARt? on page 2186
●
SEARch:RESult:USB:PACKet<m>:STOP? on page 2187
●
SEARch:RESult:USB:PACKet<m>:ADDRess? on page 2183
●
SEARch:RESult:USB:PACKet<m>:DATA? on page 2184
●
SEARch:RESult:USB:PACKet<m>:CRC? on page 2183
●
SEARch:RESult:USB:PACKet<m>:ENDPoint? on page 2184
●
SEARch:RESult:USB:PACKet<m>:ET? on page 2184
●
SEARch:RESult:USB:PACKet<m>:FRAMe? on page 2184
●
SEARch:RESult:USB:PACKet<m>:PID? on page 2185
●
SEARch:RESult:USB:PACKet<m>:PORT? on page 2185
●
SEARch:RESult:USB:PACKet<m>:SC? on page 2186
●
SEARch:RESult:USB:PACKet<m>:SEU? on page 2186
13.20.5.3 Searching USB data
Prerequisite: A serial bus is configured for the USB signal to be decoded and analyzed.
The search for events is set up in the following way:
1. Press the [Bus] key and selet the "Shortcuts" tab.
2. Tap "Setup search".
USB (option R&S R
T
O6-K570)
To Next Page
Loading...
