R&S RTO6 - 24.3.8 Power analysis (option R&S RTO6-K31); 24.3.8.1 Auto deskew

Remote control commands
R&S
®
RTO6
1277User Manual 1801.6687.02 ─ 05
SEARch:RESult:SENT:FCOunt? 'Search1'
SEARch:RESult:SENT:FRAMe1:STAT? 'Search1'
SEARch:RESult:SENT:FRAMe1:IDValue? 'Search1'
SEARch:RESult:SENT:FRAMe1:NIBB1:VALue? 'Search1'
SEARch:RESult:SENT:FRAMe1:NIBB2:VALue? 'Search1'
SEARch:RESult:SENT:FRAMe1:CSValue? 'Search1'
SEARch:TRIGger:SENT:ENHanced 'Search1', OFF
24.3.8 Power analysis (option R&S RTO6-K31)
24.3.8.1
Auto deskew
Configures the voltage and current probes for power measurements and executes the
auto deskew.
Command description in Chapter 24.23.1, "General", on page 2520 and Chap-
ter 24.23.2, "Deskew", on page 2520.
If the instrument refuses to accept POWer commands, activate the power mode
using :POWer:ENABle.
In the following example *OPC prevents overlapping execution of asynchronous com-
mands.
*RST; *OPC?
STOP;*OPC?
//Activate two channels
:CHANnel1:STATe 1
:CHANnel2:STATe 1
//Activate power
:POWer:ENABle
//Select current and voltage sources
:POWer:SOURce:VOLTage1 CHANnel1
:POWer:SOURce:CURRent1 CHANnel2
*OPC?
//Configure voltage probe on CH1 manually
//Not necessary if you use an active R&S voltage probe that is recognized by the instrument
:PROBe1:SETup:ATTenuation:MODE Manual
:PROBe:SETup:ATTenuation:DEFProbe ZD01a100
*OPC?
//selected high voltage differential probe 1:100
Programming examples