Protocol analysis
R&S
®
RTO6
865User Manual 1801.6687.02 ─ 05
"vRd-USB"
Sets the threshold at default USB Type-C current.
"vRa"
Sets the threshold for the low current.
Remote command:
BUS<m>:
USBPd:THRBottom
on page 2220
BUS<m>:USBPd:THRMid on page 2220
BUS<m>:USBPd:THRTop on page 2220
Show decode detail
If enabled, the data words are broken down into subframes. If not enabled the data
words are displayed as 32-bit data words.
If the "Show decode detail" is enabled, you cannot do a search and trigger on USBPD
frames.
Remote command:
BUS<m>:USBPd:DETail on page 2219
Show thresholds
If enabled, the threshold levels are displayed in the diagram.
Remote command:
BUS<m>:THReshold on page 1671
13.22.2.2 Display settings
Access: [Bus] > "Display" tab.
For common display settings, see Chapter 13.1.3, "Display", on page 487.
T
o enhance the decode possibilities of the USBPD protocol, you can use an additional
setting in the "Display" tab: "Decode layer".
Decode layer
Selects the decode layer.
USBPD (option R&S
RT
O6-K570)
To Next Page
Loading...
