R&S RTO6 - Results of eye

Remote control commands
R&S
®
RTO6
2416User Manual 1801.6687.02 ─ 05
Parameters:
<CommTyp> ANY | ANYC | READ | WRITe | RDNC | WRNC
ANYC: any consecutive
RDNC: read non-consecutive
WRNC: write non-consecutive
*RST: ANY
Usage: Asynchronous command
EYE<m>:FILTer:DDR:LENerror <CommTyp>
If enabled, the length errors contribute to the eye diagram.
Suffix:
<m>
.
1..4
Parameters:
<CommTyp> ON | OFF
*RST: OFF
Usage: Asynchronous command
Results of eye
EYE<m>:RESult:
SLICe<n>:COUNt?..............................................................................2416
EYE<m>:RESult:SLICe<n>:LPOSition?..........................................................................2416
EYE<m>:RESult:SLICe<n>[:POSition]?..........................................................................2417
EYE<m>:RESult:TACQs?............................................................................................. 2417
EYE<m>:RESult:TSLices?............................................................................................2417
EYE<m>:RESult:SLICe<n>:COUNt?
Returns the number of filtered bits.
Suffix:
<m>
.
1..4
<n> *
Not relevant
Return values:
<Count>
Usage: Query only
EYE<m>:RESult:SLICe<n>:LPOSition?
Returns the position of the last slice in the acquistion.
Suffix:
<m>
.
1..4
<n> *
Protocols