Remote control commands
R&S
®
RTO6
1533User Manual 1801.6687.02 ─ 05
Usage: Asynchronous command
24.12.10 Statistics and long-term measurements
See also: Chapter 24.16.7, "Long term measurement results and measurement histo-
gram export to file", on page 1659
.
MEASurement<m>:ST
ATistics[:ENABle].........................................................................1533
MEASurement<m>:CLEar.............................................................................................1533
MEASurement<m>:MULTiple........................................................................................ 1534
MEASurement<m>:MNOMeas...................................................................................... 1534
MEASurement<m>:STATistics:HISTogram......................................................................1534
MEASurement<m>:STATistics:HBINs.............................................................................1535
MEASurement<m>:STATistics:MODE............................................................................ 1535
MEASurement<m>:STATistics:RCOunt.......................................................................... 1535
MEASurement<m>:STATistics:RMEascount................................................................... 1536
MEASurement<m>:STATistics:RTIMe............................................................................ 1536
MEASurement<m>:STATistics:RESet.............................................................................1536
MEASurement<m>:VERTical:CONT.............................................................................. 1537
MEASurement<m>:VERTical:AUTO...............................................................................1537
MEASurement<m>:VERTical:OFFSet............................................................................ 1537
MEASurement<m>:VERTical:SCALe............................................................................. 1538
MEASurement<m>:LTMeas[:STATe].............................................................................. 1538
MEASurement<m>:LTMeas:COUNt............................................................................... 1538
MEASurement<m>:LTMeas:TIME..................................................................................1539
MEASurement<m>:STATistics[:ENABle] <StatisticsState>
Enables statistics calculation for the measurement.
For details on the statistics results, see Chapter 8.2.12.1, "Statistics", on page 356.
Suffix:
<m>
.
See "Selection of the measurement group: MEASurement<m>"
on page
1479.
Parameters:
<StatisticsState>
ON | OFF
*RST: OFF
Usage: Asynchronous command
MEASurement<m>:CLEar
Deletes the statistic results of the indicated mesurement.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1479.
Automatic measurements
To Next Page
Loading...
