R&S RTO6 - Bathtub

Remote control commands
R&S
®
RTO6
2500User Manual 1801.6687.02 ─ 05
Suffix:
<m>
.
1..2
Usage: Event
Asynchronous command
ADVJitter<m>:RESult:TRANsitions <TransitionT
ype>
Sets the measurements for which transitions are displayed in the diagram.
Suffix:
<m>
.
1..2
Parameters:
<TransitionType> RISing | FALLing | BOTH
*RST: BOTH
ADVJitter<m>:RESult:LEVels <LevelType>
Sets which levels are considered for the display of the diagrams, rising, falling or both.
This setting is mostly relevant for histograms.
Suffix:
<m>
.
1..2
Parameters:
<LevelT
ype> HIGH | LOW | BOTH
*RST: BOTH
Bathtub
ADVJitter<m>:DCOMposition:T
ARBer............................................................................2500
ADVJitter<m>:RESult:BATHtub..................................................................................... 2501
ADVJitter<m>:RESult:TYPBathtub.................................................................................2501
ADVJitter<m>:RESult:PJ.............................................................................................. 2501
ADVJitter<m>:RESult:OBUJ..........................................................................................2501
ADVJitter<m>:RESult:NBAThtub....................................................................................2502
ADVJitter<m>:RESult:PN..............................................................................................2502
ADVJitter<m>:RESult:OBUN.........................................................................................2502
ADVJitter<m>:DCOMposition:TARBer <TargetBtErrRate>
Sets the target bit error rate for total jitter at BER components.
Suffix:
<m>
.
1..2
Parameters:
<TargetBtErrRate> Range: 1 to 32
Increment: 1
*RST: 12
Jitter analysis and clock data recovery