Remote control commands
R&S
®
RTO6
1307User Manual 1801.6687.02 ─ 05
Usage: Asynchronous command
Firmware/software: FW 3.20
LAYout:ZOOM:ONEDiagram <ShowInOne>
Shows all zooms of a diagram in one zoom window
. The zoomed areas are overlaid for
better comparison of the zoomed waveforms.
The command takes ef
fect on all zoom diagrams.
Parameters:
<ShowInOne> ON | OFF
*RST: OFF
Usage: Asynchronous command
24.7.2.6 Annotations
To create an annotation (or waveform label), use DISPlay:
SIGNal:LABel:ADD.
Using the other DISP:SIGN:LAB:... commands, you can query the text and position
of a label, and modify the initial settings. The <LabelID> and <Source> parameters
identify each label uniquely. You can query the <LabelID> with DISPlay:SIGNal:
LABel:IDSList.
DISPlay:SIGNal:LABel:POSMode..................................................................................1307
DISPlay:SIGNal:LABel:FONTsize...................................................................................1308
DISPlay:SIGNal:LABel:ADD..........................................................................................1308
DISPlay:SIGNal:LABel:REMove.................................................................................... 1309
DISPlay:SIGNal:LABel:IDSList...................................................................................... 1310
DISPlay:SIGNal:LABel:SHOW.......................................................................................1310
DISPlay:SIGNal:LABel:STATe........................................................................................1311
DISPlay:SIGNal:LABel:TEXT........................................................................................ 1312
DISPlay:SIGNal:LABel:HORizontal:ABSolute:POSition.................................................... 1312
DISPlay:SIGNal:LABel:VERTical:ABSolute:POSition....................................................... 1312
DISPlay:SIGNal:LABel:HORizontal:RELative:POSition.................................................... 1313
DISPlay:SIGNal:LABel:VERTical:RELative:POSition........................................................1313
DISPlay:SIGNal:LABel:POSMode <Source>, <PositionMode>
DISPlay:SIGNal:LABel:POSMode? <Source>
Modifies or queries the position mode: either relative to the diagram or with absolute
values according to the units of the waveform. The position mode applies to all labels
of the selected source. For different sources, different position modes can be selected.
Parameters:
<PositionMode> ABS | REL
Instrument setup
To Next Page
Loading...
