Acquisition and waveform setup
R&S
®
RTO6
134User Manual 1801.6687.02 ─ 05
Figure 5-5: Setting the instrument into high definition mode
Enable
Enables the higher digital resolution, up to 16 bit.
Remote command:
HDEFinition:STATe on page
1387
Bandwidth
Sets the filter bandwidth for the high definition mode.
The maximum filter bandwidth depends on the instrument bandwidth.
Remote command:
HDEFinition:BWIDth on page 1387
Resolution
Shows the resulting vertical resolution in high definition mode. The higher the filter
bandwidth, the lower the resolution. For details, refer to the R&S RTO6 Specifications.
Remote command:
HDEFinition:RESolution? on page 1387
5.4.4.2 Effects of the high definition mode
The high definition mode has several effects:
Acquisition
The active high definition mode is indicated by "HD" in the "Acquisition" label.
The high definition mode works with half the realtime sample rate. For FFT, the instru-
ment halves this sample rate again.
The waveform values are recorded with 16-bit word length, except for peak detect dec-
imation (2 values with 8 bit).
Acquire settings
To Next Page
Loading...
