R&S RTO6 - 4.3.11 Protocol appearance settings

Instrument setup
R&S
®
RTO6
89User Manual 1801.6687.02 ─ 05
Color
Sets the color of samples that violated the mask.
Remote command:
MTESt:
COLor:MATCh on page
1318
Mask without violation
Sets the color of masks segments that were not hit.
Remote command:
MTESt:COLor:UNMatch on page 1318
Mask with violation
Sets the color of mask segments the signal has entered into.
Remote command:
MTESt:COLor:INTerior on page 1319
Mask with contact
Sets the color of masks segments that were touched at the border. In this case, the
resolution is not sufficient to detect if the mask was hit or not. Zoom into the concerned
area to see the actual result.
Remote command:
MTESt:COLor:BORDer on page 1318
4.3.11 Protocol appearance settings
Access: "Settings" > "Appearance" > "Protocol"
In this dialog, you can define the position of the result table for the protocol analysis.
See also Chapter 13, "Protocol analysis", on page 484.
Appearance settings